79
Optional:
Two Additional Speakers
installing SP-2000 wall mount speakers
•First observe the shape of the room: ceiling height,
door locations, windows, mounting surface, and
seating area
•Ordinary installation would be to locate the
speakers on each side wall approximately even
with the front row of listeners
•Mount the speakers 6–7 feet above the floor
•Install the mounting brackets in the vertical (up/
down) orientation
•Mount brackets using the appropriate hardware
•Insert speaker with the tweeter in upper position
•Secure speaker in bracket with the hand fasteners
•Orient each speaker toward the center of that half
of the listening area
•Strip speaker cable ends ½” and connect to
speaker
•Observe speaker polarity: Connect (+) wire
(with printed writing) to (+) terminal and (-) wire
(unprinted & textured) to the (-) terminal
•Route speaker cable to the receiver/amplifier in a
safe, least visible, tidy manner
Receiver
Amplifier
Front of Room
Wall Speakers
Ceiling Sensor
Receiver
Amplifier
Front of Room
Wall Speakers
Ceiling Sensor
final connection of the system
With receiver/amplifier located, speaker and sensor
cables neatly routed, we are ready to complete the
installation.
•Cut the speaker wire to the appropriate length
•Strip about
3
/8” off the end of each speaker
wire.
•Twist the wire and if you have a soldering iron,
tin the wire ends
•Unplug the phoenix connector, insert (+) wire
(with printed writing) into either outside (+)
terminal. Plug the other (-) wire into center (-).
•Tighten set screws.
•Repeat for other pair and insert plug firmly into
speaker receptacle
•Plug power supply into AC outlet
Commentaires sur ces manuels