Teachlogic Quantum II Manuel d'utilisateur télécharger pdf (Page 7)

assembly and installation

Mounting the Quantum II on the wall, please review the following guidelines.

• Selecting the most appropriate location for the Quantum can be the

most challenging. Every room is a little different, but in general the most

functional location is installing it on the front wall off to one side or the other

approximately from either side wall.

• An alternate choice would be on either side wall, located approximately ¼

the distance from the front of the room.

NOTE: Be conscious of an AC outlet requirement for power.

• Once you’ve decided where to mount the Quantum II, hold the ‘U’ bracket

straight up and down against the wall with bottom of the bracket approximately

5-6 feet above the ﬂoor. Using a level to assure true vertical orientation, mark

the two mounting holes.

• If installing onto a drywall, drill two ¼” holes and insert a molley bolt

provided. With a #2 Phillips head screwdriver, mount the wall bracket.

• If installing into a wood or like material, use two sheet metal screws with

washers to mount the bracket to the wall.

• For concrete wall, you’ll need to acquire and install a plastic insert for a # 8

sheet metal screw and install accordingly.

• With the bracket mounted, route the plastic wire tie through the two tab

holes. Hold the power supply onto the two raised tabs with the AC plug end

toward the ﬂoor. With the power supply resting on the pegs, tighten the wire

tie thus securing the power supply to the bracket.

• Insert the DC plug into the power input jack and place the Quantum II into

the bracket, secure each end with the bolt and washer provided.

• Orient the Quantum with center pointing diagonally across the listening

area.

• Plug the power cord into an AC outlet

The Quantum II can be operated as a free stance system on a speaker stand.

To use in this mode of operation:

• Locate the system off to one side in the front of the room. Point the front

of the unit toward the center of the listening area. Find an AC outlet and plug

the system in.

• Side wall location is also acceptable. Locate unit on either side about ¼

from front of room. Point the front diagonally across the listening area. Locate

an AC outlet and plug it in.

Optional: Folding Tripod Stand SS-300

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Teachlogic Quantum II Manuel d'utilisateur Page 7