owner’s manual
4
Maxim III
8
Ceiling Sensor
Listening Area
Ceiling Speakers
Listening Area
Front of Room
Ceiling Speakers
Ceiling Sensor
Optional:
Two Additional Speakers
installation of speakers
installing two SP-628 ceiling speakers
•Determine the listening area.
•Divide listening area into two quadrants
•Locate and identify the center most tile in each
quadrant
•Lay ceiling tile face down on clean flat surface
•Lay tile bridge on ceiling tile and center it
•Trace and cut the large hole using a keyhole or
drywall saw
•Strip the speaker cable ends, approx. ½"
•Route speaker wire from speaker opening to
amplifier
•Reinstall ceiling tile with tile bridge in place above
the hole
•Pull speaker cable back down through speaker
hole
•With a pointed tool or paper clip, lift up and
remove speaker grille
•Set speaker on top of ladder and connect speaker
cable connect
•Observe speaker polarity, connect Red wire to (+)
terminal and black wire to the (C) terminal
•With the mounting clamps folded back, position
speaker into speaker hole
•With a #2 Phillips screwdriver, tighten the quick
clamps
•Reinstall speaker grille and remove any soil or
fingerprints
•Repeat same for other speaker
Two wall mount or ceiling speakers can be powered by the receiver/amplifier. It has two amplifiers
(25 watts ea.). One speaker will be connected to each amplifier.
Optional: Two additional speakers can be powered by the amplifier. Connect two speakers in
parallel. Then bring a cable from each pair to the amplifier. Connect one pair to each amplifier.
Commentaires sur ces manuels