Teachlogic Maxim III Manuel d'utilisateur télécharger pdf (Page 18)

transmitterowner’s manual

page over-ride/page pass through

Maxim III

The page over-ride feature allows you to connect the TeachLogic ampliﬁer to

the school paging/intercom system for muting purposes. A simple connection

between the in-classroom paging speaker (typically 25v or 70v) and the

TeachLogic page input will mute all the inputs and pass the page to the speakers

connected to the TeachLogic ampliﬁer

Unplug the 2 pin green Phoenix connector

Connect the speaker cable from the paging system to the 2 pin

Phoenix connector of the Page input

Reconnect the 2 pin green Phoenix connector

Determine the signal level of the paging system (25v, 70v, or 100v)

Set the slide switch to the appropriate speaker level setting

With the TeachLogic ampliﬁer turned ON, send a page signal through

the page input

Adjust the page input SENSITIVITY control so that an incoming

page/intercom signal will override any audio (mics, dvd etc) plugged

into the TeachLogic ampliﬁer.

In the event of a loss of AC power, the TeachLogic ampliﬁer will continue to

pass the page on to 2 of the speaker connections as outlined on the following

diagram. Only the upper left and lower right speaker outputs will pass page

without power.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Pas de commentaire

Teachlogic Maxim III Manuel d'utilisateur Page 18