Teachlogic Maxim III Manuel d'utilisateur télécharger pdf (Page 22)

transmitterowner’s manual

Maxim III

system operation

•Turn the Maxim III “ON”, Blue LED will light

•Conﬁrm power to sensor, Green LED on edge of

sensor

•Set volume of Ch A volume control to mid scale

(12 o’clock)

•Using a Sapphire Transmitter microphone select

channel “A” (Mics are shipped in channel A)

• Sapphire: “A–B” switch, remove battery cover

on back, under battery.

• Handheld: Unscrew barrel and remove.

Note “A–B” switch on side of battery holder.

•Turn volume control on Sapphire transmitter to

"Hi" level. This is the normal setting.

•Switch transmitter “on”

•Observe power LED (Blue) - use fully charged

battery only

•Observe signal presence LED (Orange) on

receiver adjacent to “Mic” volume control

•Stand under or in front of a speaker

•Slowly adjust “Ch A” volume on Maxim III while

talking into microphone

•Adjust to desired listening level.

CAUTION: Beware of feedback

•Walk around the room while talking into

microphone to conﬁrm good connectivity

Upon completion of performance test,

the installation is complete.

operation of wireless microphone

Now that the system is installed and connected, we are ready to turn the system “ON” and test

its performance. The testing will be done using an IR transmitter (Sapphire or Handheld) to

conﬁrm good connectivity and quality audio.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Teachlogic Maxim III Manuel d'utilisateur Page 22