Teachlogic Quantum II Manuel d'utilisateur télécharger pdf (Page 14)

owner’s manual

Quantum II

note

system operation

•On Quantum II set Ch A & B volume controls to

off (counter clock wise)

•Turn the Quantum II “ON”, Blue LED will light

•Conﬁrm power to ceiling sensor, Green LED on

edge of sensor will light

•Using a Sapphire Transmitter microphone.

(Sapphire Mics are shipped in channel A)

• Sapphire: “A–B” switch, remove battery cover

on back, under battery.

• Handheld: Unscrew barrel and remove.

Note “A–B” switch on side of battery holder.

•Turn sensitivity control on Sapphire transmitter

to "HI" level position

•Switch transmitter “on” by depressing and hold

front button until (Blue) LED is present

•Observe signal presence LED (Orange) on

Quantum II receiver adjacent to “Mic” volume

control

•Stand under or in front of a speaker

•Slowly adjust “Ch A” volume on Quantum II

while talking into microphone

•Adjust to desired listening level.

CAUTION: Beware of feedback

•Walk around the room while talking into

microphone to conﬁrm good connectivity

Upon completion of performance test,

the installation is complete.

Now that the system is installed and connected, we are ready to turn the system “ON” and test

its performance. The testing will be done using an IR transmitter (Sapphire or Handheld) to

conﬁrm good connectivity and quality audio.

operation of wireless microphone

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Teachlogic Quantum II Manuel d'utilisateur Page 14